The 6' and 7' Gondola Blimps have all their hardware inside the gondola. The blimps use two 1/3 oz. motors with differential vectored thrust to provide proportional up, down, left, right, fore, and aft movement. They can perform near vertical takeoffs and landings, and are a close replica of the "GOODYEAR" Style Blimp. These blimp can be flown in gymnasiums, large conference rooms, auditoriums, and convention centers.
The kits are complete with all parts necessary to assemble as shown. You will need to provide your own 3 or 4 channel transmitter, receiver, one or two micro servos and battery pack, or purchase radio equipment listed below.

7' GONDOLA BLIMPS
Description:
The 7' Gondola Blimps can carry signs, logos, small miniature cameras, coupon droppers, etc. Typically it can carry an addition payload of approximately 7 ounces.

This bag is made from a polyurethane material. It has a slightly different rudder style which uses one additional servo. Available in white, red, black, or clear.
Specifications:
Assembly time: 8 hours
Length: 7' Width: 4' Height: 2.4'
Speed: 10 MPH Horizontal
Speed: 3 MPH Vertical
Turning Radius: 4'
Propulsion: Dual 1/3 ounce motors with 6" propellers
Bag capacity: 24 cubic feet
Bag Weight: 8.2 ounces
Additional Lift capacity: 7 ounces
| Item #0422-W | White | $465.95 |
| Item #0422-R | Red | $465.95 |

This bag is made from a metalized nylon (balloon) material. Only one servo is needed if you elect not to use rudder control.
Specifications:
Assembly time: 8 hours
Length: 7' Width: 2' Height: 2'
Speed: 10 MPH Horizontal
Speed: 3 MPH Vertical
Turning Radius: 4'
Propulsion: Dual 1/3 ounce motors with 6" propellers
Bag capacity: 16 cubic feet
Bag Weight: 5 ounces
Additional Lift capacity: 5 ounces
| Item #0416 | White | $369.95 |
6' GONDOLA BLIMPS
Description:
The 6' Gondola Blimps can carry small signs or logos. Typically it can carry an addition payload of 4 ounces.

This bag is made from a polyurethane material. It has a slightly different rudder style and uses one additional servo. Available in white, red, black, or clear.
Specifications for 6' bag:
Assembly time: 8 hours
Length: 6' Width: 2' Height: 2'
Speed: 10 MPH Horizontal
Speed: 3 MPH Vertical
Turning Radius: 4'
Propulsion: Dual 1/3 ounce motors with 6" propellers
Bag capacity: 18 cubic feet
Bag Weight: 6.7 ounces
Additional Lift capacity: 4 ounces
| Item #0420-W | White | $449.95 |
| Item #0420-R | Red | $449.95 |
| Item #0420-B | Black | $449.95 |

This bag is made from a metalized nylon (balloon) material. Only one servo is needed if you elect not to use rudder control.
Specifications:
Assembly time: 8 hours
Length: 6' Width: 2' Height: 2'
Speed: 10 MPH Horizontal
Speed: 3 MPH Vertical
Turning Radius: 3'
Propulsion: Dual 1/3 ounce motors with 6" propellers
Bag capacity: 10 cubic feet
Bag weight: 4 ounces
Additional Lift Capacity: 2 ounces
| Item #0411 | White | $354.95 |

RADIO EQUIPMENT Futaba Skysport 4 channel transmitter with an Alpex receiver, 2 ultra micro servos, 350 Mah 4-cell battery pack, and charger. Radio equipment will be set up to operate any of the above blimps.

| Item #1497 | $175.95 |


NOTE: ALL OF THE ABOVE BLIMPS ARE MADE STRICTLY FOR INDOOR USE!
These blimps provide all of the flying enjoyment of a true proportional aircraft.

| OPEN: | JANUARY - JULY | |
| OPEN: | OCTOBER - DECEMBER | |
| CLOSED: | AUGUST - SEPTEMBER |
John and Carol Piri
WCBlimps@mchsi.com
Last updated: January, 2008